ADJ Gobo Motion LED Manual de Instruções descarregar pdf (Página 6)

American DJ® - www.americandj.com - Gobo Motion LED Instruction Manual Page 11

and press Enter.

LED - With this function you can switch the LED on or off

via the control board.

1. Press the MENU button until “LED” is displayed, press

ENTER.

2. The display will show either “ON” or “OFF”. Press the UP or

DOWN buttons to select “ON” to switch on the LED, or “OFF” to

switch o the LED.

3. Press ENTER to conrm and exit.

DISP - This function will reverse the display 180º.

1. Press the MENU button until “DISP” is displayed, press

ENTER.

2. Press the UP button to select “DSIP” to activate this function,

or “DISP” to deactivate this function.

3. Press ENTER to conrm.

TEST - This function will run a self test program.

1. Press the MENU button until “TEST” is displayed, press

ENTER.

2. The xture will now run a self test.

FHRS - With this function you can display the running time

of the unit.

1. Press the MENU button until “FHRS” is displayed, press

ENTER.

2. The display shows the running time of the unit. Press MENU

to exit.

Gobo Motion LED System Menu

VER - Use this function to display the Software version of

the unit.

1. Press the MENU button until “VER” is displayed, press

ENTER.

2. The display will show the software version.

Gobo Motion LED System Menu

American DJ® - www.americandj.com - Gobo Motion LED Instruction Manual Page 12

Gobo Motion LED Power Cord Daisy Chain

With this feature you can connect the xtures to one another

using the IEC input and output sockets. The quantity that can be

connected is 9 xtures maximum. After 9 xtures you will need

to use a new power outlet. They must be the same xtures. DO

NOT mix xtures.

Gobo Motion LED Gobo Replacement

The Gobo Motion LED comes with 6 replaceable gobos. These

gobos can be interchanged at any time and allows you to customize

your system.

To replace gobo;

1. Unscrew the thumb screw located at the top that hold the gobo

housing.

2. Remove the gobo housing.

3. Once the gobo housing has been removed, remove the retaining

ring that holds the gobo in place. This can easily be done using

needle nose pliers.

4. Remove and replace the gobo with your desired replacement.

Reinsert the retainer ring, and make sure the ring rests firmly

against the gobo.

5. Slide the gobo assembly back into place, and secure the housing

using thumb screw.

1 2 3 4 5 6 7 8 9 10

Comentários a estes Manuais

Sem comentários

ADJ Gobo Motion LED Manual de Instruções Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Holofotes ADJ Gobo Motion LED